Powering On An Ac-Powered Srx5400 Services Gateway - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
Related
Documentation

Powering On an AC-Powered SRX5400 Services Gateway

66
Figure 29: Connecting AC Power to the Services Gateway
AC Power Cord Specifications for the SRX5400 Services Gateway on page 195
Preventing Electrostatic Discharge Damage to the SRX5400 Services Gateway on
page 155
Overview of Installing the SRX5400 Services Gateway on page 33
Tools and Parts Required for SRX5400 Services Gateway Grounding and Power
Connections on page 63
Grounding the SRX5400 Services Gateway on page 64
Powering On an AC-Powered SRX5400 Services Gateway on page 66
Powering Off the SRX5400 Services Gateway on page 72
To power on an AC-powered services gateway:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Verify that the power supplies are fully inserted in the chassis.
2.
Verify that each AC power cord is securely inserted into the appliance inlet.
3.
Verify that an external management device is connected to one of the Routing Engine
4.
ports ( , , or
AUX CONSOLE
Turn on the power to the external management device.
5.
Switch on the dedicated customer site circuit breakers for the power supplies. Follow
6.
the ESD and safety instructions for your site.
Move the AC input switch on each power supply to the on (
7.
the status LEDs on each power supply faceplate. If an AC power supply is correctly
).
ETHERNET
Copyright © 2014, Juniper Networks, Inc.
) position and observe
|