2-Port 10-Gigabit Ethernet Xpim Leds; Figure 20: 2-Port 10-Gigabit Ethernet Xpim; Table 48: 2-Port 10-Gigabit Ethernet Xpim Led States - Juniper SRX Series Manual

2-Port 10-Gigabit Ethernet XPIM LEDs

Copyright © 2015, Juniper Networks, Inc.
2-Port 10-Gigabit Ethernet XPIM Components on page 84
2-Port 10-Gigabit Ethernet XPIM Basic Configuration on page 223
The 2-Port 10 Gigabit Ethernet XPIM has the LEDs listed in

Table 48: 2-Port 10-Gigabit Ethernet XPIM LED States

LED Color
STATUS Green
Yellow
Red
LINK/ACT Link Green
for fiber ports
Activity Green
LINK/ACT Link Green
for copper ports
NOTE: Each port has
two LEDs; one on
Activity Green
either side of the port.
The left LED is activity
and the right is link.
Figure 20 on page 89 shows the 2-Port 10-Gigabit Ethernet XPIM.

Figure 20: 2-Port 10-Gigabit Ethernet XPIM

Chapter 12: 2-Port 10-Gigabit Ethernet XPIM
Table 48 on page
State Description
On XPIM is online and functioning
normally.
On XPIM is starting up, running
diagnostics, or shutting down.
On XPIM has failed.
Off XPIM has no power and can be
pulled out safely.
On Port is online.
Off Port is offline.
Blinking Port is sending data.
NOTE: For fiber ports, the Activity
LED does not blink when the port is
only receiving data.
Off Port might be on but is not receiving
or sending data.
On Port is online.
Off Port is offline.
Blinking Port is sending data.
Off Port might be on but is not receiving
or sending data.
89.
89