2-Port 10 Gigabit Ethernet Xpim Leds - Juniper SRX Series Manual

2-Port 10-Gigabit Ethernet XPIM Components | 84
2-Port 10-Gigabit Ethernet XPIM Basic Configuration | 217

2-Port 10 Gigabit Ethernet XPIM LEDs

The 2-Port 10 Gigabit Ethernet XPIM has the LEDs listed in
Table 46: 2-Port 10 Gigabit Ethernet XPIM LED States
LED
STATUS
LINK/ACT
for fiber ports
LINK/ACT
for copper ports
NOTE: Each port has two
LEDs; one on either side of
the port. The left LED is
activity and the right is
link.
Color State
Green On
Amber On
Red On
Off
Link Green On
Off
Activity Green Blinking
Off
Link Green On
Off
Activity Green Blinking
Off
Table 46 on page 90.
Description
XPIM is online and functioning normally.
XPIM is starting up, running diagnostics,
or shutting down.
XPIM has failed.
XPIM has no power and can be pulled out
safely.
Port is online.
Port is offline.
Port is sending data.
NOTE: For fiber ports, the Activity LED
does not blink when the port is only
receiving data.
Port might be on but is not receiving or
sending data.
Port is online.
Port is offline.
Port is sending data.
Port might be on but is not receiving or
sending data.
90