Stand-Alone (Point-To-Point) Connection To A Pc - Agilent Technologies InfiniiVision 2000 X-Series User Manual

19
Utility Settings
3 Press the LAN Settings softkey.
4 Press the Config softkey; then, turn the Entry knob to select Automatic,
5 Configure the oscilloscope's LAN interface:
6 Connect the oscilloscope to the local area network (LAN) by inserting

Stand-alone (Point-to-Point) Connection to a PC

The following procedure describes how to establish a point- to- point (stand
alone) connection to the oscilloscope. This is useful if you want to control
the oscilloscope using a laptop computer or a stand- alone computer.
1 Press [Utility] > I/O.
2 Press the LAN Settings softkey.
3 Press the Config softkey; then, turn the Entry knob to select Automatic,
4 Connect your PC to the oscilloscope using a cross- over LAN cable such
5 Cycle power on the oscilloscope. Wait until the LAN connection is
240
and press the softkey again to disable it.
If Automatic is not enabled, the oscilloscope's LAN configuration must
be set up manually using the Addresses and Host name softkeys
a Press the Addresses softkey.
b Use the Modify softkey (and the other softkeys and the Entry knob)
to enter the IP Address, Subnet Mask, Gateway IP, and DNS IP
values. When you are done, go back up in the menu hierarchy.
c Press the Host name softkey. Use the softkeys and the Entry knob to
enter the Host name. When you are done, go back up in the menu
hierarchy.
d Press the Apply softkey.
the LAN cable into the "LAN" port on the rear panel of the
oscilloscope.
and press the softkey again to enable it.
If your network supports DHCP or AutoIP, enabling Automatic lets the
oscilloscope use those services to get its LAN configuration settings
as Agilent part number 5061- 0701, available on the web at
"www.parts.agilent.com".
configured:
Press [Utility] > I/O and wait until the LAN status shows "configured".
•
Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide