Configuring Interfaces - Alcatel-Lucent 7210 SAS T Configuration Manual

Configuring Interfaces

The following command sequences create a system and a logical IP interface. The system interface
assigns an IP address to the interface, and then associates the IP interface with a physical port. The
logical interface can associate attributes like an IP address or port.
Note that the system interface cannot be deleted.
Configuring a System Interface
To configure a system interface:
CLI Syntax: config>router
Configuring a Network Interface
Note: Network interface is supported only on 7210 SAS devices operating in network mode and it
is not supported on 7210 SAS devices operating in access-uplink mode.
To configure a network interface:
CLI Syntax: config>router
7210 SAS M, T, X, R6, R12, Mxp OS Router Configuration Guide
interface interface-name
address {[ip-address/mask]|[ip-address] [netmask]}
[broadcast {all-ones|host-ones]
interface interface-name
address ip-addr{/mask-length | mask} [broadcast {all-
ones | host-ones}]
egress
filter ip ip-filter-id
ingress
filter ip ip-filter-id
port port-name
IP Router Configuration
Page 43