Mac-Address-Table Static-Multicast - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

mac-address-table static-multicast

Configures a static multicast MAC address and assigns the address to one or more egress ports. Packets
received on ports associated with the specified VLAN that contain a destination MAC address that
matches the static multicast address are forwarded to the specified egress ports. Static multicast MAC
addresses are maintained in the Source Learning MAC address table.
mac-address-table static-multicast multicast_address {slot1/port1[-port1a] [slot2/port2[-port2a]...] |
linkagg link_agg} vid
no mac-address-table static-multicast [multicast_address {slot1/port1[-port1a] [slot2/port2[-port2a]...] |
linkagg link_agg} vid]
Syntax Definitions
multicast_address
slot1/port1[-port1a]
slot2/port2[-port2a]
link_agg
vid
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to remove a static multicast MAC address from the Source Learning
MAC Address Table. Note that if no parameters are specified with this form of the command, then all
static multicast addresses are removed.
•
Note that a MAC address is considered a multicast MAC address if the least significant bit of the most
significant octet of the address is enabled. For example, MAC addresses with a prefix of 01, 03, 05, 13,
etc., are multicast MAC addresses.
•
If a multicast prefix value is not present, then the address is treated as a regular MAC address and not
allowed when using the mac-address-table static-multicast command. Also note that multicast
addresses within the following ranges are not supported:
01:00:5E:00:00:00 to 01:00:5E:7F:FF:FF
01:80:C2:XX.XX.XX
33:33:XX:XX:XX:XX
page 4-8
Enter the destination multicast MAC Address to add to the MAC
Address Table (e.g., 01:00:39:59:f1:0c).
The egress slot and port combination that is assigned to the static multi-
cast MAC address. You may enter multiple ports and port ranges.
Additional egress slot and port combinations may be assigned to the
static multicast MAC address. You may enter multiple ports and port
ranges.
Enter a link aggregate ID number (0–29). See
gation Commands."
VLAN ID number (1–4094).
Source Learning Commands
Chapter 8, "Link Aggre-
OmniSwitch CLI Reference Guide June 2012