Fujitsu PRIMEQUEST 1000 Series User Manual page 864

Replace the HDD. Perform a rebuild. If the Fault LED is not on, a SAS interface
system failure may have occurred. Replace the possibly faulty component of the
SAS interface system.
However, this event may have occurred at operating system startup after the
optional card or the hard disk of the server where this product is installed was
added or removed. In such cases, use ServerView RAID Manager to check the
status of the array. There is no problem if the array is recognized as being in the
normal state.
Severity:
Error
Action:
(R/M/T/S)
28558
SV RAID:%2 Adapter error (Logical drive missing after reboot) vendor-
id=1000 device-id=%d revision=%r
Meaning:
The logical drive could not be found at restart.
%2: Device name
%d: (Example) 0079
%r: Numerical value (1 to 3 digits)
Corrective action:
This event may have occurred at operating system startup after the optional card
or the hard disk of the server where this product is installed was added or
removed. In such cases, use ServerView RAID Manager to check the status of
SVmco User Guidel
856