Fujitsu PRIMEQUEST 1000 Series User Manual page 77

SVmco User Guide

Confirming the PSA-to-MMB communication LAN and management LAN

Configuring the management LAN

Configuring the PSA-to-MMB communication LAN
Usually, the network is configured as shown below immediately after the
installation of the operating system.
The interface name, BUS number, and other names must be replaced with
suitable character strings according to the environment.
Network configuration immediately after installation of OS
Remark
For details on each command used in the settings below, use man for
confirmation.
Note
Do not set the host name before setting the IP address of vswif0, which exists by
default immediately after the installation of the operating system. If you do so,
VMware may change the value of /etc/hosts to an unintended value.
The description here is based on the assumption that vswif0 is used as the
management LAN.
69