Fujitsu PRIMEQUEST 1000 Series User Manual page 46

Required/
Setting item
As needed
Setting trap
destinations
Setting Watchdog
for monitoring
after a STOP error
(fatal system
As
error)
needed
Installing a SVmco
update
Uninstalling
SVmco (*3)
*1 Automatic setting: Values are automatically set during SVmco installation.
You may need to change an automatically set value. See the section listed in the
table.
*2 Manual setting: Values are not automatically set during SVmco installation.
Make settings as described in the section referred to in the table.
*3 To operate the PRIMEQUEST 1000x2 series server, you need to first install
SVmco. If you uninstall SVmco, the following restrictions apply.

Even under an REMCS agreement, no software errors are reported.

Hot maintenance of hard disks is disabled. The partition must be
stopped for maintenance.
Automatic
setting (*1)/
Manual setting
(*2)
Manual 2.2.6 Setting trap
setting destinations
2.2.7 Setting the
Manual Watchdog Timer for
setting monitoring after a STOP
error (fatal system error)
2.2.8 Installing a SVmco
Not applicable
update
2.2.9 Uninstalling
Not applicable
SVmco
SVmco User Guidel
See
38