Fujitsu PRIMEQUEST 1000 Series User Manual page 14

Required/
Setting item
As
needed
Setting the
management LAN
IP address
As Setting the
needed destinations of
traps from a
partition
Configuring SNMP
to use duplicate
disks
Installing a SVmco
update
Uninstalling
SVmco (*3)
*1 Automatic setting: Values are automatically set during SVmco installation.
You may need to change an automatically set value. See the section listed in the
table.
*2 Manual setting: Values are not automatically set during SVmco installation.
Make settings as described in the section referred to in the table.
*3 To operate the PRIMEQUEST 1000x2 series server, you need to first install
. If you uninstall SVmco, the following restrictions apply.
SVmco

Even under an REMCS agreement, no software errors are reported.
Automatic
setting (*1)/
Manual
setting (*2)
Manual 2.1.5 Setting the
setting management
LAN IP address
Manual 2.1.6 Setting the
setting destinations of
traps from a
partition
Manual 2.1.7
setting Configuring
SNMP to use
duplicate disks
Not 2.1.8 Installing a
applicable SVmco update
Not 2.1.9
applicable Uninstalling
SVmco
SVmco User Guidel
See
6