Fujitsu PRIMEQUEST 1000 Series User Manual page 79

SVmco User Guide
In the above example, vmnic0 is used for the PSA-to-MMB communication
LAN, and vmnic1is used for the management LAN.

Configuring the management LAN
1. Use vswif0, which exists by default immediately after the installation of
the operating system, for the interface of the management LAN.
Execute the esxcfg-vswif command to confirm the status of vswif0.
# esxcfg-vswif -l
Name Port Group/DVPort IP Family IP Address \
Netmask Broadcast Enabled TYPE
vswif0 Service Console IPv4 N/A \
N/A N/A true NONE
\: This indicates that there is no line feed.
The above example shows that vswif0 has been set for the Port Group
name of "Service Console."
2. Execute the esxcfg-vswitch command to confirm the status of the virtual
switch.
# esxcfg-vswitch -l
Switch Name Num Ports Used Ports Configured Ports \
MTU Uplinks
vSwitch0 64 2 64 \
71