Fujitsu PRIMEQUEST 1000 Series User Manual page 195

SVmco User Guide
Suppose that you are going to replace IOB#0-PCIC#5. The red box
indicates the target device.
Some multifunction cards differ only in the part after FUNC in the Unit
name. Also, some differ only in the Func number at [Seg/Bus/Dev/Func].
Perform the following steps 2 to 9 for each of these multifunction cards.
2. Select the Unit name of the NIC to be replaced in the [Driver Monitor]
window and record MAC address. Search recorded MAC address from
[System Status] - [Network] - [Network Interface] and record the "IP
Address" and "IP Subnet Mask" values under "IP v4 Interfaces" in order to
search for the device to be replaced or set these values again after
replacement.
3. Start iSCSI Initiator.
Starting [iSCSI Initiator]
The following steps 4 to 9 vary depending on the version, Windows Server
2008 or Windows Server 2008 R2 or later.
187