Fujitsu PRIMEQUEST 1000 Series User Manual page 43

SVmco User Guide
When you update SVmco, it is necessary to stop and start ServerView Agents. If
ServerView Agents is not stopped, some files can not be replaced.
1. Stop the ServerView Agents service
# srvmagt stop
2. Stop the SVmco service
# /sbin/service y30SVmco stop
3. Change the current directory to SVmco in $WORK_DIR:
# cd $WORK_DIR/SVmco
4. Enter the following command to start installation:
# ./INSTALL.sh
5. Start the SVmco service
# /sbin/service y30SVmco start
6. Start the ServerView Agents service
# srvmagt start
Notes of SVmco update
- When updating SVmco on PRIMECLUSTER system, please stop
PRIMECLUSTER
according to the PRIMECLUSTER Installation and Administration Guide.
- Because PRIMECLUSTER function stops during update or restart of SVmco
temporarily, either of two kinds of PRIMECLUSTER messages might be
35