Epson S1C33210 Technical Manual page 468

V DMA BLOCK: HSDMA (High-Speed DMA)
Intelligent DMA
Intelligent DMA (IDMA) can be invoked by the end-of-transfer interrupt factor of channels 0 and 1 of HSDMA.
The following shows the IDMA channels set in HSDMA:
Channel 0 end-of-transfer interrupt: 0x05
Channel 1 end-of-transfer interrupt: 0x06
Before IDMA can be invoked, the corresponding bits of the IDMA request and IDMA enable registers must be
set to "1". Settings of transfer conditions on the IDMA side are also required.
If the IDMA request and enable bits are set to "1", IDMA is invoked through generation of an interrupt factor.
No interrupt request is generated at that point. An interrupt request is generated after the DMA transfer is
completed. The registers can also be set so as not to generate an interrupt, with only a DMA transfer performed.
For details on IDMA transfers and interrupt control upon completion of IDMA transfer, refer to "IDMA
(Intelligent DMA)".
Trap vector
The trap vector addresses for interrupt factors in each channel are set by default as follows:
Channel 0 end-of-transfer interrupt: 0x0C00058
Channel 1 end-of-transfer interrupt: 0x0C0005C
Channel 2 end-of-transfer interrupt: 0x0C00060
Channel 3 end-of-transfer interrupt: 0x0C00064
Note that the trap table base address can be modified using the TTBR registers (0x48134 to 0x48137).
B-V-2-16
IDMA channel
Table 2.4 Control Bits for IDMA Transfer
Channel IDMA request bit
Ch. 0 RHDM0(D4/0x40290)
Ch. 1 RHDM1(D5/0x40290)
IDMA enable bit
DEHDM0(D4/0x40294)
DEHDM1(D5/0x40294)
EPSON
S1C33210 FUNCTION PART