Epson S1C33210 Technical Manual page 173

Write cycle with wait mode
Example: When the BCU has no internal wait mode, and 1 wait cycle is inserted via the #WAIT pin
BCLK
A[23:0]
#CExx
D[15:0]
#WRH/#WRL
#WAIT
#WR
#BSL/#BSH
The #WAIT signal is sampled at the falling edge of the transition of BCLK (bus clock), and the write cycle is
terminated in the cycle immediately following the cycle in which the #WAIT signal was sampled in an
inactive (high level).
Note: Insertion of wait cycles via the #WAIT pin is possible only when the device for bus conditions is set
to SRAM and SWAIT (D0) / Bus control register (0x4812E) is enabled for waiting.
The above example shows a write cycle when a wait mode is inserted via the #WAIT signal. A wait mode
consisting of 2 to 7 cycles can also be inserted using the wait control bits. The settings of these bits also can be
used in combination with the #WAIT signal. In this case as well, the #WAIT signal is sampled at the falling
edge of the transition of BCLK. However, even when the #WAIT signal is inactive before the wait cycles set by
the wait control bits are terminated, the write cycle is not terminated at that time.
Note: The basic write cycle consists of at least two cycles. This does not change regardless of whether
zero or one wait cycle is set by the wait control bits. If the number of wait cycles set is 2 or more,
the bus cycle is actually extended. In this case, the bus write cycle consists of [number of wait
cycles + 1], as in the case of read cycles (providing that there is no external wait).
S1C33210 FUNCTION PART
C1 CW
Figure 4.25 Half-word Write Cycle with Wait
EPSON
II CORE BLOCK: BCU (Bus Control Unit)
C2
addr
data
B-II-4-21