Table of Contents
Advertisement
Chapter 2
Administrative Commands
ntp
To synchronize the clock on your Server Switch to primary, secondary, and tertiary NTP servers, enter
the ntp command in Global Configuration mode. To reset an NTP configuration to the default value, use
the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
This command has no default settings.
Command Modes
Global Configuration (config) mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Unrestricted read-write user.
Use the ntp command to configure your Server Switch to take time information from up to three servers
so that your Server Switch can identify a problem when one server sends faulty data packets. We strongly
recommend that you configure all three servers for maximum precision.
Examples
The following example assigns primary, secondary, and tertiary NTP servers to the Server Switch:
SFS-7000P(config)# ntp server-one 10.0.3.110
SFS-7000P(config)# ntp server-two 10.0.3.111
SFS-7000P(config)# ntp server-three 10.0.3.112
Related Commands
clock set
show clock
show ntp
snmp-server
OL-9163-02
ntp {server-one | server-two | server-three} ip-address
no ntp {server-one | server-two | server-three}
Cisco SFS 7000 Series Product Family Command Reference Guide
ntp
2-55
Advertisement
Table of Contents
