Table of Contents
Advertisement
stop
stop
To end a diagnostic test, enter the stop command in the appropriate Interface DiagnosticConfiguration
submode.
Syntax Description
This command has no arguments or keywords.
Defaults
This command has no default settings.
Command Modes
Fibre Channel Interface Diagnostic Configuration (config-diag-if-fc) submode, Ethernet Interface
Diagnostic Configuration (config-diag-if-en) submode, or Card Interface Diagnostic Configuration
(config-diag-if-card) submode, Card Diagnostic Configuration submode, (config-diag-card), Chassis
Diagnostic Configuration submode (config-diag-chassis), Fan Diagnostic Configuration submode
(config-diag-fan), Power Supply Diagnostic Configuration submode (config-diag-power-supply), Rack
Locator Diagnostic Configuration submode (config-diag-rack-locator), InfiniBand Interface Diagnostic
Configuration submode (config-diag-if-ib)
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Fibre Channelread-write user.
Examples
The following example stops the test running on Fibre Channel port 4/1:
SFS-7000P(config-diag-if-fc-4/1)# stop
The following example stops the test running on card 6:
FS-7000P (config-diag-card-6)# stop
Related Commands
diagnostic
show interface ethernet
show interface fc
show interface gateway
start
test
Cisco SFS 7000 Series Product Family Command Reference Guide
7-224
stop
Chapter 7
Diagnostic Commands
OL-9163-02
Advertisement
Table of Contents
