Table of Contents
Advertisement
Chapter 6
Show Commands
Examples
The following example displays the completed and ongoing diagnostic tests on port 1 of Ethernet
gateway 9:
SFS-7000P# show diagnostic interface ethernet 9/1
================================================================================
================================================================================
Failed=0, Total=0
The following example displays the diagnostic tests available:
SFS-7000P# (config)# diagnostic interface ethernet 2/1
SFS-7000P# (config-diag-if-ether-2/1)# ?
>diagnostic Configuration Commands:
data-pattern
cases
data-size
exit
help
history
iterations
should be run
no
start
stop
test
validate
received packets
SFS-7000P# (config-diag-if-ether-2/1)# test ?
ext-loopback
led
Related Commands
show diagnostic
OL-9163-02
Diagnostic Tests For Ethernet Interfaces
test : led
port : 9/1
validation : enabled
data-size : 0
data-pattern : 00:00:00:00
iterations : 0
action : stop
result : none
percentage-completed : 0
result-string : Unknown Test Unknown status, Current report : Passed=0,
- Configure a data pattern to use in traffic test
- Configure size (in octects) of payload data
- Exit current mode
- Show command help
- Show command history
- Configure number of iterations the test case
- Disable a configuration or set default
- Initiate a test
- Stop a test
- Configure the test case to run
- Enable data validation to be performed on
- Configure External-Loopback test
- Configure LED test
Cisco SFS 7000 Series Product Family Command Reference Guide
show diagnostic interface ethernet
6-41
Advertisement
Table of Contents
