Table of Contents
Advertisement
ip http
ip http
To enable or configure HTTP and HTTPS services on your Server Switch, enter the ip http command
in Global Configuration mode. To disable service or change a port number to the default value, use the
no form of this command.
Syntax Description
polling
port
secure
-cert-common-name
server
useSysName
useMgmtEnetIpAddr
useMgmtIbIpAddr
secure-port
secure-server
number
Defaults
The HTTP port value defaults to 80.
HTTP services on your Server Switch run by default.
The HTTPS port value defaults to 443.
HTTPS services on your Server Switch run by default.
Command Modes
Global Configuration (config) mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Cisco SFS 7000 Series Product Family Command Reference Guide
2-44
ip http {polling | port number | secure-cert-common-name {useSysName |
useMgmtEnetIpAddr | useMgmtIbIpAddr} | secure-port | secure-server | server}
no ip http {polling | port | secure-port | secure-server | server}
Enables polling on the Server Switch.
Specifies the HTTP port that the HTTP server uses. Returns the port
configuration to the default value (80) when you use the no form of the
command.
Specifies where to get the common name used to generate a SSL certificate.
Enables the HTTP server on your Server Switch. Use this keyword with the
no form of the command to disable the HTTP server.
Configures your Server Switch to use its system name (that you configure
with the hostname command) in SSL certificates.
Configures your Server Switch to use the IP address of its Ethernet
Management Port in SSL certificates.
Configures your Server Switch to use the IP address of its InfiniBand
Management Port in SSL certificates.
Specifies the HTTPS port that the HTTP server uses. Returns the port
configuration to the default value (443) when you use the no form of the
command.
Enables HTTPS with Secure Sockets Layer (SSL) on your Server Switch.
Use this keyword with the no form of the command to disable HTTPS.
HTTP port (integer) that the HTTP server uses.
Chapter 2
Administrative Commands
OL-9163-02
Advertisement
Table of Contents
