Table of Contents
Advertisement
boot-config
boot-config
To specify the system image to run when your Server Switch boots, enter the boot-config command in
Global Configuration mode.
Syntax Description
primary-image-source
dir
Defaults
This command has no default settings.
Command Modes
Global Configuration (config) mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Unrestricted read-write user.
Specify an image directory as a boot image. Do not specify image files that end in ".img" since these are
compressed archives that must be installed first.
Note
Use the dir command with the image keyword to view a list of images on your device.
Examples
The following example configures the Server Switch controller to use the sfsOS-1.1.0/build460 directory
when the Server Switch boots. Without this directory, the system cannot boot successfully.
SFS-7000P(config)# boot-config primary-image-source sfsOS-1.1.0/build460
Related Commands
dir
install
radius-server
reload
show boot-config
show card
show card-inventory
Cisco SFS 7000 Series Product Family Command Reference Guide
2-10
boot-config primary-image-source dir
Specifies that you want to configure the boot image.
Directory that contains the boot image.
Chapter 2
Administrative Commands
OL-9163-02
Advertisement
Table of Contents
