Table of Contents
Advertisement
reload
reload
To reboot your Server Switch, enter the reload command in Privileged Exec mode.
Syntax Description
no-failover (Cisco SFS
3012 only)
Defaults
This command has no default settings.
Command Modes
Privileged Execute mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
General read-write user.
At stages of chassis and interface setup, you need to reinitialize chassis firmware or restore interface card
configurations. Use the reload command because it allows the chassis to close files and prepare for
shutdown. The reload command brings down the entire Server Switch and restarts all of the cards in the
Server Switch.
The Server Switch prompts you to verify the reload. If you have not already saved configuration changes,
and the Server Switch detects the changes, it prompts you to save. To store the new configuration as the
startup configuration, enter yes at the prompt. To store the configuration elsewhere under a different file
name, enter the new file name and press Enter.
The system reinitializes itself and then loads the active system image and the startup configuration file.
Wait a few minutes and attempt to log onto the chassis.
Note
If your Server Switch includes a second controller card, the CLI will prompt you to save changes to the
backup controller as well as to the primary controller.
Examples
The following example reloads the Server Switch:
SFS-7000P# reload
System configuration has been modified. Save?
[yes(default)/no/*.cfg] yes
Proceed with reload? [confirm]
SFS-7000P#
Connection to host lost.
#
Cisco SFS 7000 Series Product Family Command Reference Guide
2-60
reload [no-failover]
(Optional) Forces a Cisco SFS 3012 to run from the same controller card
when it reboots. By default, Cisco SFS 3012 Server Switches swap active
controller cards when they reboot.
Chapter 2
Administrative Commands
OL-9163-02
Advertisement
Table of Contents
