Table of Contents
Advertisement
test
test
Specify a diagnostic test to run with the test command in appropriate Diagnostic Configuration submode.
Note
The SFS 7000 does not support external loopback tests for InfiniBand interfaces. Table 7-8 describes
the different tests that you can run and the interfaces or cards on which you can run them.
echo
Syntax Description
int-loopback
ext-loopback
led
self-test
ext-cable
Defaults
This command has no default settings.
Command Modes
Fibre Channel Interface Diagnostic Configuration (config-diag-if-fc) submode, Ethernet Interface
Diagnostic Configuration (config-diag-if-en) submode, InfiniBand Interface Diagnostic Configuration
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Read-write user.
Examples
The following example specifies a LED test to run on card 11 when the start command executes:
SFS-7000P (config-diag-card-11)# test LED
Related Commands
diagnostic
show interface ethernet
show interface fc
show interface gateway
start
stop
Cisco SFS 7000 Series Product Family Command Reference Guide
7-226
test {echo | int-loopback | ext-loopback | led | self-test}
Echo test (Fibre Channel gateway only).
Internal loopback test (unsupported).
External loopback test (Fibre Channel gateway only).
LED test.
Self test.
External cable test (unsupported).
Chapter 7
Diagnostic Commands
OL-9163-02
Advertisement
Table of Contents
