Table of Contents
Advertisement
show ib pm port counter config
show ib pm port counter config
To display the port counter configuration whether access to port counters is either enabled or disabled,
enter the show ib pm port counter config subnet-prefix command in User Execute mode or Privileged
Execute mode. Use the following syntax for this version of the command:
Syntax Description
config
subnet-prefix
prefix
Defaults
This command has no default settings.
Command Modes
User Execute mode, Privileged Execute mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
General read-only user.
Command Output Description:
subnet-prefix
state
Examples
The following example shows the configuration of the performance monitoring port counter:
SFS-120# show ib pm port counter config subnet-prefix fe:80:00:00:00:00:00:00
================================================================================
IB PM Port Counter Configuration
================================================================================
subnet-prefix : fe:80:00:00:00:00:00:00
state : enabled
Cisco SFS 7000 Series Product Family Command Reference Guide
6-88
show ib pm port counter config subnet-prefix prefix
Port counter configuration.
Specifies the subnet prefix of the counters to view.
Subnet prefix of the counters to view.
Subnet to which the port counter configuration applies.
State of port counter access. If 'enabled', then access to port counters is enabled.
Chapter 6
Show Commands
OL-9163-02
Advertisement
Table of Contents
