Table of Contents
Advertisement
Chapter 6
Show Commands
Examples
The following example displays the completed and ongoing diagnostic tests on all Ethernet ports:
SFS-7000P# show diagnostic interface ethernet all
================================================================================
================================================================================
Failed=0, Total=0
The following example displays the diagnostic tests available:
SFS-7000P(config)# diagnostic interface fc 6/1
SFS-7000P(config-diag-if-fc-6/1)# ?
> diagnostic Configuration Commands:
>
data-pattern
> cases
>
data-size
>
exit
>
help
>
history
>
iterations
> should be run
>
no
>
source-id
>
start
>
stop
>
target-id
>
test
>
validate
> received packets
> Topspin-360(config-diag-if-fc-6/1)# test ?
>
echo
>
ext-loopback
>
int-loopback
Related Commands
show diagnostic
OL-9163-02
Diagnostic Tests For Ethernet Interfaces
test : external-loopback
port : 6/3
validation : enabled
data-size : 0
data-pattern : 00:00:00:00
iterations : 0
action : stop
result : none
percentage-completed : 0
result-string : External Loopback Test In-progress, Current report : Passed=0,
- Configure a data pattern to use in traffic test
- Configure size (in octects) of payload data
- Exit current mode
- Show command help
- Show command history
- Configure number of iterations the test case
- Disable a configuration or set default
- Specify source identifier for use with FC Echo test
- Initiate a test
- Stop a test
- Specify target identifier for use with FC Echo test
- Configure the test case to run
- Enable data validation to be performed on
- Configure Echo test
- Configure External-Loopback test
- Configure Internal-Loopback test
Cisco SFS 7000 Series Product Family Command Reference Guide
show diagnostic interface fc
6-43
Advertisement
Table of Contents
