Table of Contents
Advertisement
show card
Command Output:
Table 6-8
Table 6-8
Field
slot
admin type
oper type
admin status
oper status
Cisco SFS 7000 Series Product Family Command Reference Guide
6-18
describes the fields in the show card command output.
show card Command Field Descriptions
Description
Displays the number of the slot that the card occupies.
Displays the type of the interface card that the administrator specified with the
type command. The first two letters of the entry indicate the general type of
the card:
en for Ethernet
•
ib for InfiniBand
•
fc for Fibre Channel
•
The number of ports on the card follow the two-letter type identifier. The
remaining number and letter identify the speed of the ports on the card. The
admin type fc2port2G indicates a Fibre Channel card with two ports that run
at a maximum speed of 2 Gbps.
The controller and controllerIb12port4x cards serve as an exception to
Note
these rules.
The "admin type" identifier "controller" indicates the type of independent
controller card found on both sides of the system chassis. The "admin type"
identifier "controllerIb12port4x" indicates a controller card that piggy-backs
onto a 12-port InfiniBand switch card, where each port connection can support
speeds up to 4X.
Displays the type of the card as detected by the controller. If any conflict
occurs between "admin type" and "oper type", the system assumes that the
type specified by oper type is correct and allows you to configure the card
based upon this assumption. If a type mismatch occurs, verify that you are
selecting the correct type for the card in the chassis.
Displays the administrative status (that you configure with the shutdown and
no shutdown commands) of the port.
Displays the operational status as detected by the controller. Oper status
represents the absolute status of the interface card based upon self-detection.
The value of this read-only field appears as one of the following:
•
unknown, which generally indicates that an error occurred when the card
booted
•
up, which indicates that the card is operating normally
•
down, which indicates that a user disabled the card with the shutdown
command
•
failure, which indicates that the card failed to boot correctly
The "up" indicator means that your card is operating normally. You can only
configure cards that have an operational status of "up."
Chapter 6
Show Commands
OL-9163-02
Advertisement
Table of Contents
