Table of Contents
Advertisement
Chapter 7
Diagnostic Commands
diagnostic
To enter Diagnostic Configuration submode, enter the diagnostic command in Global Configuration
mode.
Not all syntax applies to all hardware platforms. Enter Diagnostic submode to run test on cards and
Note
interfaces.
card
Syntax Description
card-selection
chassis
fan
interface
fc
ib
ethernet
interface-selection
all
power-supply
rack-locator
Defaults
This command has no default settings.
Command Modes
Global Configuration (config) mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Note
The SFS 3001 and SFS 3012 can run card and interface tests only. For the SFS 7000 and SFS 7008, the
rack-locator keyword supports only 12x, not 4x.
Privilege Level:
Read-write user for the appropriate technology.
OL-9163-02
diagnostic {card {card-selection | all} | chassis | interface
| all} | fan {fan-number | all} | power-supply {supply | all} | rack-locator {locator | all}}
Enters Card Diagnostic Configuration submode.
Card, list of cards, or range of cards to diagnose.
Configures chassis-specific diagnostic tests.
Configures fan-specific diagnostic tests.
Enters Interface Diagnostic Configuration submode.
Specifies Fibre Channel interfaces.
Specifies InfiniBand interfaces.
Specifies Ethernet interfaces.
Interface, list of interfaces, or range of interfaces to diagnose.
Specifies all interfaces of the technology type that you specified for all
cards.
Configures power supply-specific diagnostic tests.
Configures rack locator-specific diagnostic tests.
{
Cisco SFS 7000 Series Product Family Command Reference Guide
fc | ib | ethernet} {interface-selection
diagnostic
7-217
Advertisement
Table of Contents
