Table of Contents
Advertisement
show boot-config
show boot-config
To display the active system image that runs when your Server Switch boots, enter the show
boot-config command in User Exec mode or Privileged Exec mode.
Syntax Description
This command has no arguments or keywords.
Defaults
No default behavior or values
Command Modes
User Execute mode, Privileged Execute mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
General read-only user.
The show boot-config command displays the image that initializes chassis firmware and configures
the interfaces.
This command lists the files that were used to bring up the system, the files to use the next time the
system reboots, and the backup files to use in the event that the primary boot files are not available.
Command Output:
Table 6-4
Table 6-4
Field
slot-id
sw-version
last-image-source
primary-image-source
Cisco SFS 7000 Series Product Family Command Reference Guide
6-10
show boot-config
describes the fields in the show boot-config command output.
show boot-config Command Field Descriptions
Description
Slot identifier of the controller card in use.
Version of the software image that initialized chassis components.
Directory name of the active system image used to initialize chassis
components.
Name and directory location of the active system image to use to initialize
chassis components the next time the system boots.
Chapter 6
Show Commands
OL-9163-02
Advertisement
Table of Contents
