Configuring Dhcp, Ntp, Dns And Snmp Settings - Cisco Catalyst 9404R Switch Hardware Installation Manual

Initial Configuration for the Switch
Figure 72: VLAN and STP Settings

Configuring DHCP, NTP, DNS and SNMP Settings

Procedure
Step 1
In the Domain Details section, enter a domain name that the software uses to complete unqualified hostnames.
Step 2 Type an IP address to identify the DNS server. This server is used for name and address resolution on your
device.
Step 3 In the Server Details section, type the IP address of the DNS server that you want to make available to DHCP
clients.
Step 4
In the Syslog Server field, type the IP address of the server to which you want to send syslog messages.
Step 5 To ensure that your device is configured with the right time, date and timezone, enter the IP address of the
NTP server with which you want to synchronize the device time.
Step 6 In the Management Details section, type an IP address to identify the SNMP server. SNMPv1, SNMPv2,
and SNMPv3 are supported on your device.
Step 7 Specify the SNMP community string to permit access to the SNMP protocol.
Configuring DHCP, NTP, DNS and SNMP Settings
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
149