Table of Contents
Advertisement
Chapter 7
Diagnostic Commands
data-pattern
To specify a data pattern when you run a diagnostic test on an interfaces, enter the data-pattern command
in Interface Diagnostic Configuration submode. To clear the data pattern, use the no form of this
command.
pattern
Syntax Description
Defaults
This command has no default settings.
Command Modes
Interface Diagnostic Configuration (config-diag-if) mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Unrestricted and general read-write user.
Examples
The following example configures the data pattern that runs during a diagnostic test:
SFS-7000P(config-diag-if-fc-4/1)# data pattern 11:22:33:44
Related Commands
test
diagnostic
start
stop
show interface ethernet
show interface fc
show interface ib
OL-9163-02
data-pattern pattern
no data-pattern pattern
Artificial traffic pattern to create for testing purposes.
Cisco SFS 7000 Series Product Family Command Reference Guide
data-pattern
7-219
Advertisement
Table of Contents
