Table of Contents
Advertisement
install
install
To install an image file on your Server Switch, enter the install command in Privileged Exec mode.
Syntax Description
slot-number
image
file
Image files must reside in the image file system and the file name must have the .img extension.
Defaults
This command has no default settings.
Command Modes
Privileged Execute mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Unrestricted read-write user.
To run a new system image, you must follow these steps:
Step 1
Download an image file to your Server Switch. See the copy command at the
page
Step 2
Power up all modules in your chassis.
Step 3
Install the image file with the install command.
Configure your Server Switch to run the new system image when it boots. See the boot command at the
Step 4
"boot-config" section on page
(Optional) Execute the action command with the delete-inactive-images keyword for each card in
Step 5
your chassis to remove old images.
The install command performs everything necessary to install a new system image to flash memory.
The command automatically installs all necessary firmware and component images, and then updates all
cards with an administrative status of up.
To update additional cards, re-enter the install and boot-config commands after you add the cards.
Cisco SFS 7000 Series Product Family Command Reference Guide
2-42
install [slot-number:]image:file
(Optional) Slot of the controller card (1 on the Cisco SFS 3001, Cisco SFS
7000, and Cisco 4x InfiniBand Switch Module for IBM BladeCenter; 1 or
14 on the Cisco SFS 3012; 11 or 12 on the Cisco SFS 7008).
Specifies that the file resides in the image file-system.
The name of the image file to install.
2-26.
2-10.
Chapter 2
Administrative Commands
"copy" section on
OL-9163-02
Advertisement
Table of Contents
