Enable (Ospf); Network Area (Ospf) - NETGEAR GSM7228PS Cli Manual

enable (OSPF)

This command resets the default administrative mode of OSPF in the router (active).
Default enabled
Format
enable
Mode Router OSPF Config
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
Format
no enable
Mode Router OSPF Config

network area (OSPF)

Use this command to enable OSPFv2 on an interface and set its area ID if the IP address of an
interface is covered by this network command.
Default disabled
Format
network <ip-address> <wildcard-mask> area <area-id>
Mode Router OSPF Config
no network area (OSPF)
Use this command to disable the OSPFv2 on a interface if the IP address of an interface was earlier
covered by this network command.
Format
no network <ip-address> <wildcard-mask> area <area-id>
Mode Router OSPF Config
Routing Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
4-40