Private-Group Name - NETGEAR GSM7228PS Cli Manual

By default, a port does not belong to any private group. A port cannot be in more than one private
group. An error message should return when that occurred. To change a port's private group, first
the port must be removed from its private group.
Default port not associated with any group.
Format
switchport private-group [<privategroup-name>|<privategroup-id>]
Mode Interface Config
no switchport private group
This command is used to remove the specified port from the given private group.
Format
no switchport private-group [<privategroup-name>|<privategroup-id>]
Mode Interface Config

private-group name

This command is used to create a private group with name <private-group-name>. The name
string can be up to 24 bytes of non-blank characters. The total number of private groups is 192
such that the valid range for the ID is <1-192>.
The <private-group-id> field is optional. If not specified, a group id not used will be assigned
automatically.
The mode can be either "isolated" or "community". When in "isolated" mode, the member port in
the group cannot forward its egress traffic to any other members in the same group. By default, the
mode is "community" mode that each member port can forward traffic to other members in the
same group, but not to members in other groups.
Format
{<privategroup-name> mode [community|isolated]|<groupid>}
Mode Global Config
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-55