Show Ipv6 Ospf Interface Stats - NETGEAR GSM7228PS Cli Manual

Format
show ipv6 ospf interface brief
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
Admin Mode States whether OSPF is enabled or disabled on a router interface.
Area ID The OSPF Area ID for the specified interface.
Router Priority The router priority. The router priority determines which router is the designated router.
Hello Interval The frequency, in seconds, at which the interface sends Hello packets.
Dead Interval The amount of time, in seconds, the interface waits before assuming a neighbor is down.
Retransmit The frequency, in seconds, at which the interface sends LSA.
Interval
Retransmit The number of seconds the interface adds to the age of LSA packets before
Delay Interval
transmission.
LSA Ack The amount of time, in seconds, the interface waits before sending an LSA
Interval
acknowledgement after receiving an LSA.

show ipv6 ospf interface stats

This command displays the statistics for a specific interface. The command only displays
information if OSPF is enabled.
Format
show ipv6 ospf interface stats <unit/slot/port>
Modes • Privileged EXEC
• User EXEC
Term Definition
OSPFv3 Area ID The area id of this OSPF interface.
IPv6 Address The IP address associated with this OSPF interface.
OSPFv3 The number of times the specified OSPF interface has changed its state, or an error has
Interface Events
occurred.
IPv6 Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
7-63