Ip Ospf Area; Enable (Ospf); Network Area (Ospf) - NETGEAR ProSafe GSM7224P User Manual

enable (OSPF)

This command resets the default administrative mode of OSPF in the router (active).
Default
enabled
Format
enable
Mode
Router OSPF Config
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
Format
no enable
Mode
Router OSPF Config

network area (OSPF)

Use this command to enable OSPFv2 on an interface and set its area ID if the IP address of
an interface is covered by this network command.
Default
disabled
Format
network <ip-address> <wildcard-mask> area <area-id>
Mode
Router OSPF Config
no network area (OSPF)
Use this command to disable the OSPFv2 on a interface if the IP address of an interface was
earlier covered by this network command.
Format
no network <ip-address> <wildcard-mask> area <area-id>
Mode
Router OSPF Config

ip ospf area

Use this command to enable OSPFv2 and set the area ID of an interface. The <area-id> is
an IP address formatted as a 4-digit dotted-decimal number or a decimal value in the range
of <0-4294967295>. This command supersedes the effects of the network area
command. It can also be used to configure the advertiseability of the secondary addresses
on this interface into the OSPFv2 domain.
Default
disabled
Format
ip ospf area <area-id> [secondaries none]
Mode
Interface Config
ProSafe Managed Switch
Routing Commands
269