Show Network Ndp; Ping Ipv - NETGEAR GSM7228PS Cli Manual

show network ndp

This command displays NDP cache information for the network port.
Default enabled
Format
show network ndp
Mode • Privileged EXEC
• User EXEC
Field Description
IPv6 Address The IPv6 address of the interface.
MAC Address The MAC Address used.
isRtr Specifies the router flag.
Neighbor State The state of the neighbor cache entry. Possible values are: Reachable, Delay.
Age Updated The time in seconds that has elapsed since an entry was added to the cache.
Example: The following shows example CLI display output for the command.
(Switch) #show network ndp
IPv6 Address
-------------------------- ----------------- -----
3017::204:76FF:FE73:423A 00:04:76:73:42:3a
FE80::204:76FF:FE73:423A 00:04:76:73:42:3a

ping ipv6

Use this command to determine whether another computer is on the network. Ping provides a
synchronous response when initiated from the CLI and Web interfaces. To use the command,
configure the switch for network (in-band) connection. The source and target devices must have
the ping utility enabled and running on top of TCP/IP. The switch can be pinged from any IP
workstation with which the switch is connected through the default VLAN (VLAN 1), as long as
there is a physical path between the switch and the workstation. The terminal interface sends three
pings to the target station. Use the <ipv6-address|hostname> parameter to ping an
interface by using the global IPv6 address of the interface. Use the optional size keyword to
specify the size of the ping packet.
IPv6 Commands
Managed Switch CLI Manual, Release 8.0.3
MAC Address isRtr
v1.0, July 2010
Neighbor Age
State Updated
-------- -------
Reachable 447535
Delay 447540
7-4