Show Supported Switchtype - NETGEAR GSM7228PS Cli Manual

Term Definition
Switch Status The switch status. Possible values are OK, Unsupported, Code Mismatch, Config
Mismatch, or Not Present.
Switch The switch description.
Description
Expected Code The expected code version.
Version
Detected Code The version of code running on this switch. If the switch is not present and the data is
Version
from pre-configuration, then the code version is "None".
Detected Code in The version of code that is currently stored in FLASH memory on the switch. This code
Flash
executes after the switch is reset. If the switch is not present and the data is from pre-
configuration, then the code version is "None".
Up Time The system up time.

show supported switchtype

This commands displays information about all supported switch types or a specific switch type.
Format
show supported switchtype [<switchindex>]
Mode User EXEC
Privileged EXEC
If you do not supply a value for <switchindex>, the following output appears:
Term Definition
Switch Index (SID) The index into the database of supported switch types. This index is used when
preconfiguring a member to be added to the stack.
Model Identifier The model identifier for the supported switch type.
Management The management preference value of the switch type.
Preference
Code Version The code load target identifier of the switch type.
If you supply a value for <switchindex>, the following output appears:
Term Definition
Switch Type The 32-bit numeric switch type for the supported switch.
Stacking Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
2-9