Protocol Vlan Group - NETGEAR GSM7228PS Cli Manual

Default none
Format
protocol group <groupid> <vlanid>
Mode VLAN Config
no protocol group
This command removes the <vlanid> from this protocol-based VLAN group that is identified
by this <groupid>.
Format
no protocol group <groupid> <vlanid>
Mode VLAN Config

protocol vlan group

This command adds the physical interface to the protocol-based VLAN identified by
<groupid>. You can associate multiple interfaces with a group, but you can only associate each
interface and protocol combination with one group. If adding an interface to a group causes any
conflicts with protocols currently associated with the group, this command fails and the
interface(s) are not added to the group.
Default none
Format
protocol vlan group <groupid>
Mode Interface Config
no protocol vlan group
This command removes the interface from this protocol-based VLAN group that is identified by
this <groupid>.
Format
no protocol vlan group <groupid>
Mode Interface Config
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-39