Passive-Interface Default (Ospf) - NETGEAR GSM7228PS Cli Manual

passive-interface default (OSPF)

Use this command to enable global passive mode by default for all interfaces. It overrides any
interface level passive mode. OSPF will not form adjacencies over a passive interface.
Default disabled
Format
passive-interface default
Mode Router OSPF Config
no passive-interface default
Use this command to disable the global passive mode by default for all interfaces. Any interface
previously configured to be passive reverts to non-passive mode.
Format
no passive-interface default
Mode Router OSPF Config
passive-interface (OSPF)
Use this command to set the interface or tunnel as passive. It overrides the global passive mode
that is currently effective on the interface or tunnel.
Default disabled
Format
passive-interface {<unit/slot/port>}
Mode Router OSPF Config
no passive-interface
Use this command to set the interface or tunnel as non-passive. It overrides the global passive
mode that is currently effective on the interface or tunnel.
Format
no passive-interface {<unit/slot/port>}
Mode Router OSPF Config
Routing Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
4-62