Show Running-Config - NETGEAR GSM7228PS Cli Manual

MbufsFree
MbufsRxUsed
Total Rx Norm Alloc Attempts
Total Rx Mid2 Alloc Attempts
Total Rx Mid1 Alloc Attempts
Total Rx High Alloc Attempts
Total Tx Alloc Attempts
Total Rx Norm Alloc Failures
Total Rx Mid2 Alloc Failures
Total Rx Mid1 Alloc Failures
Total Rx High Alloc Failures
Total Tx Alloc Failures

show running-config

Use this command to display or capture the current setting of different protocol packages
supported on the switch. This command displays or captures commands with settings and
configurations that differ from the default value. To display or capture the commands with settings
and configurations that are equal to the default value, include the [all] option.
Note: Show running-config does not display the User Password, even if you set one
different from the default.
The output is displayed in script format, which can be used to configure another switch with the
same configuration. If the optional <scriptname> is provided with a file name extension of
".scr", the output is redirected to a script file.
Note: If you issue the show running-config command from a serial connection, access to
the switch through remote connections (such as Telnet) is suspended while the
output is being generated and displayed.
Note: If you use a text-based configuration file, the show running-config
command will only display configured physical interfaces, i.e. if any interface only
contains the default configuration, that interface will be skipped from the show
running-config command output. This is true for any configuration mode that
contains nothing but default configuration. That is, the command to enter a
particular config mode, followed immediately by its 'exit' command, are both
omitted from the show running-config command output (and hence from
the startup-config file when the system configuration is saved.)
Utility Commands
150
0
26212
4087
188943
384555
2478536
0
0
0
0
0
v1.0, July 2010
Managed Switch CLI Manual, Release 8.0.3
9-15