Set Mld Groupmembership-Interval - NETGEAR GSM7228PS Cli Manual

no set mld fast-leave
Use this command to disable MLD Snooping fast-leave admin mode on a selected interface.
Format
no set mld fast-leave <vlanid>
Mode • VLAN Mode
Format
no set mld fast-leave <vlanid>
Mode • Interface Config

set mld groupmembership-interval

Use this command to set the MLD Group Membership Interval time on a VLAN, one interface or
all interfaces. The Group Membership Interval time is the amount of time in seconds that a switch
waits for a report from a particular group on a particular interface before deleting the interface
from the entry. This value must be greater than the MLDv2 Maximum Response time value. The
range is 2 to 3600 seconds.
Default 260 seconds
Format
set mld groupmembership-interval <vlanid> <2-3600>
Mode • VLAN Mode
Default 260 seconds
Format
set mld groupmembership-interval <2-3600>
Mode • Interface Config
• Global Config
no set groupmembership-interval
Use this command to set the MLDv2 Group Membership Interval time to the default value.
Format
no set mld groupmembership-interval <vlanid>
Mode • VLAN Mode
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-156