IPv6 Multicast Forwarder
show ipv6 mroute
Note: There is no specific IP multicast enable for IPv6. Enabling of multicast at global
config is common for both IPv4 and IPv6.
Use this command to show the mroute entries specific for IPv6. (This command is the IPv6
equivalent of the IPv4 show ip mcaste mroute command.)
Format
show ipv6 mroute {detail | summary}
Modes
• Privileged EXEC
• User EXEC
If you use the detail parameter, the command displays the following Multicast Route Table
fields:
Term
Definition
Source IP
The IP address of the multicast data source.
Group IP
The IP address of the destination of the multicast packet.
Expiry Time
The time of expiry of this entry in seconds.
Up Time
The time elapsed since the entry was created in seconds.
RPF Neighbor
The IP address of the RPF neighbor.
Flags
The flags associated with this entry.
If you use the summary parameter, the command displays the following fields:
Term
Definition
Source IP
The IP address of the multicast data source.
Group IP
The IP address of the destination of the multicast packet.
Protocol
The multicast routing protocol by which the entry was created.
Incoming
The interface on which the packet for the source/group
Interface
arrives.
IPv6 Multicast Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
6-2