Show Lldp Med Interface - NETGEAR GSM7228PS Cli Manual

show lldp med interface

Use this command to display a summary of the current LLDP MED configuration for a specific
interface. <unit/slot/port> indicates a specific physical interface. all indicates all valid
LLDP interfaces.
Format
show lldp med interface {<unit/slot/port> | all}
Mode Privileged Exec
Term Definition
Interface The interface in a unit/slot/port format.
Link Shows whether the link is up or down.
ConfigMED Shows if the LLPD-MED mode is enabled or disabled on this interface
OperMED Shows if the LLPD-MED TLVs are transmitted or not on this interface.
ConfigNotify Shows if the LLPD-MED topology notification mode of this interface.
TLVsTx Shows whether the interface sends optional TLVs in the LLDPDUs. The TLV codes
can be 0 (Capabilities), 1 (Network Policy), 2 (Location), 3 (Extended PSE), 4
(Extended Pd), or 5 (Inventory).
Example: The following shows example CLI display output for the command.
(Switch) #show lldp med interface all
Interface Link
--------- ------
1/0/1 Down
1/0/2 Up
1/0/3 Down
1/0/4 Down
1/0/5 Down
1/0/6 Down
1/0/7 Down
1/0/8 Down
1/0/9 Down
1/0/10 Down
1/0/11 Down
1/0/12 Down
1/0/13 Down
1/0/14 Down
Switching Commands
configMED operMED
--------- --------
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
v1.0, July 2010
Managed Switch CLI Manual, Release 8.0.3
ConfigNotify TLVsTx
------------ -----------
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
Disabled 0,1
3-186