Set Mld Mcrtexpiretime; Set Mld Mrouter - NETGEAR GSM7228PS Cli Manual

set mld mcrtexpiretime

Use this command to set the Multicast Router Present Expiration time. The time is set for the
system, on a particular interface or VLAN. This is the amount of time in seconds that a switch
waits for a query to be received on an interface before the interface is removed from the list of
interfaces with multicast routers attached. The range is 0 to 3600 seconds. A value of 0 indicates
an infinite timeout, i.e. no expiration.
Default 0
Format
set mld mcrtexpiretime <0-3600>
Mode • Global Config
• Interface Config
Default 0
Format
set mld mcrtexpiretime <vlanid> <0-3600>
Mode • VLAN Config
no set mld mcrtexpiretime
Use this command to set the Multicast Router Present Expiration time to 0. The time is set for the
system, on a particular interface or a VLAN.
Format
no set mld mcrtexpiretime
Mode • Global Config
• Interface Config
Format
no set mld mcrtexpiretime <vlanid>
Mode • VLAN Mode

set mld mrouter

Use this command to configure the VLAN ID for the VLAN that has the multicast router attached
mode enabled.
Format
set mld mrouter <vlanid>
Mode Interface Config
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-158