Show Ip Mcast Mroute Source - NETGEAR GSM7228PS Cli Manual

Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Protocol The multicast routing protocol by which this entry was created.
Incoming The interface on which the packet for this group arrives.
Interface
Outgoing The list of outgoing interfaces on which this packet is forwarded.
Interface List

show ip mcast mroute source

This command displays the multicast configuration settings such as flags, timer settings, incoming
and outgoing interfaces, RPF neighboring routers, and expiration times of all the entries in the
multicast mroute table containing the given source IP address or source IP address and group IP
address pair.
Format
show ip mcast mroute source <sourceipaddr> {summary | detail}
Modes • Privileged EXEC
• User EXEC
If you use the detail parameter, the command displays the following column headings in the
output table:
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Expiry Time The time of expiry of this entry in seconds.
Up Time The time elapsed since the entry was created in seconds.
RPF Neighbor The IP address of the RPF neighbor.
Flags The flags associated with this entry.
If you use the summary parameter, the command displays the following column headings in the
output table:
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
IP Multicast Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
5-6