Deny | Permit} (Mac Acl) - NETGEAR GSM7228PS Cli Manual

{deny | permit} (MAC ACL)

This command creates a new rule for the current MAC access list. Each rule is appended to the list
of configured rules for the list.
Note: The 'no' form of this command is not supported, since the rules within a MAC ACL
cannot be deleted individually. Rather, the entire MAC ACL must be deleted and
re-specified.
Note: An implicit 'deny all' MAC rule always terminates the access list.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, the source and destination MAC value must be specified, each of which may be
substituted using the keyword any to indicate a match on any value in that field. The remaining
command parameters are all optional, but the most frequently used parameters appear in the same
relative order as shown in the command format.
The Ethertype may be specified as either a keyword or a four-digit hexadecimal value from
0x0600-0xFFFF. The currently supported <ethertypekey> values are: appletalk, arp, ibmsna,
ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of these translates into its
equivalent Ethertype value(s).
Ethertype Keyword
appletalk
arp
ibmsna
ipv4
ipv6
ipx
mplsmcast
mplsucast
netbios
novell
pppoe
rarp
Quality of Service (QoS) Commands
Corresponding Value
0x809B
0x0806
0x80D5
0x0800
0x86DD
0x8037
0x8848
0x8847
0x8191
0x8137, 0x8138
0x8863, 0x8864
0x8035
v1.0, July 2010
Managed Switch CLI Manual, Release 8.0.3
8-34