Match Ip6Flowlbl; Match Destination-Address Mac; Match Dstip - NETGEAR GSM7228PS Cli Manual

match ip6flowlbl

This command adds to the specified class definition a match condition based on the IP6flowlbl of
a packet. The label is the value to match in the Flow Label field of the IPv6 header (range 0-
1048575).
Format
match ip6flowlbl <label>
Mode Ipv6-Class-Map Configuration mode

match destination-address mac

This command adds to the specified class definition a match condition based on the destination
MAC address of a packet. The <macaddr> parameter is any layer 2 MAC address formatted as
six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The
<macmask> parameter is a layer 2 MAC address bit mask, which need not be contiguous, and is
formatted as six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc).
Note: This command is not available on the GSM73xxSv1 platform.
Default none
Format
match destination-address mac <macaddr> <macmask>
Mode Class-Map Config
Ipv6-Class-Map Config

match dstip

This command adds to the specified class definition a match condition based on the destination IP
address of a packet. The <ipaddr> parameter specifies an IP address. The <ipmask>
parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits.
Default none
Format
match dstip <ipaddr> <ipmask>
Mode Class-Map Config
Quality of Service (QoS) Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
8-14