Show Switch - NETGEAR GSM7228PS Cli Manual

show switch

This command displays information about all units in the stack or a single unit when you specify
the unit value.
Format
show switch [<unit>]
Mode Privileged EXEC
Term Definition
Switch The unit identifier assigned to the switch.
When you do not specify a value for <unit>, the following information appears:
Term Definition
Management Indicates whether the switch is the Primary Management Unit, a stack member, or the
Status
status is unassigned.
Preconfigured The model identifier of a preconfigured switch ready to join the stack. The Model
Model Identifier
Identifier is a 32-character field assigned by the device manufacturer to identify the
device.
Plugged-In Model The model identifier of the switch in the stack. Model Identifier is a 32-character field
Identifier
assigned by the device manufacturer to identify the device.
Switch Status The switch status. Possible values for this state are: OK, Unsup ported, Code
Mismatch, Config Mismatch, or Not Present.
Code Version The detected version of code on this switch.
When you specify a value for <unit>, the following information appears:
Term Definition
Management Indicates whether the switch is the Primary Management Unit, a stack member, or the
Status
status is unassigned.
Hardware The hardware management preference of the switch. The hardware management
Management
preference can be disabled or unassigned.
Preference
Admin The administrative management preference value assigned to the switch. This
Management
preference value indicates how likely the switch is to be chosen as the Primary
Preference
Management Unit.
Switch Type The 32-bit numeric switch type.
Model Identifier The model identifier for this switch. Model Identifier is a 32-character field assigned by
the device manufacturer to identify the device.
Stacking Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
2-8