Interface Range; Interface Vlan; Interface Lag - NETGEAR GSM7228PS Cli Manual

interface range

This command gives you access to a range of port interfaces, allowing the same port configuration
to be applied to a set of ports.
Format
interface range <unit/slot/port>-<unit/slot/port>
Mode Global Config

interface vlan

This command gives you access to to the vlan virtual interface mode, which allows certain port
configurations (for example, the IP address) to be applied to the VLAN interface. Type a question
mark (?) after entering the interface configuration mode to see the available options.
Format
interface vlan <vlan id>
Mode Global Config

interface lag

This command gives you access to the LAG (link aggregation, or port channel) virtual interface,
which allows certain port configurations to be applied to the LAG interface. Type a question mark
(?) after entering the interface configuration mode to see the available options.
Note: The IP address cannot be assigned to a LAG virtual interface. The interface must
be put under a VLAN group and an IP address assigned to the VLAN group..
Format
interface lag <lag id>
Mode Global Config
auto-negotiate
This command enables automatic negotiation on a port.
Default enabled
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-3