Internet Group Message Protocol (Igmp) Commands - NETGEAR GSM7228PS Cli Manual

show ip pimsm rp mapping
Use this command to display all group-to-RP mappings of which the router is a aware (either
configured or learned from the bootstrap router (BSR)). If no RP is specified, all active RPs are
displayed.
Format
show ip pimsm rp mapping [rp address]
Modes • Privileged EXEC
• User EXEC

Internet Group Message Protocol (IGMP) Commands

This section describes the commands you use to view and configure IGMP settings.
ip igmp
This command sets the administrative mode of IGMP in the system to active.
Default disabled
Format
ip igmp
Modes • Global Config
• Interface Config
no ip igmp
This command sets the administrative mode of IGMP in the system to inactive.
Format
no ip igmp
Modes • Global Config
• Interface Config
IP Multicast Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
5-26