Mac Database Commands; Bridge Aging-Time - NETGEAR GSM7228PS Cli Manual

Term Definition
TCP FIN&URG& May be enabled or disabled. The factory default is disabled.
PSH Mode
TCP Flag & May be enabled or disabled. The factory default is disabled.
Sequence Mode
TCP SYN Mode May be enabled or disabled. The factory default is disabled.
TCP SYN & FIN May be enabled or disabled. The factory default is disabled.
Mode
TCP Fragment May be enabled or disabled. The factory default is disabled.
Mode
TCP Offset May be enabled or disabled. The factory default is disabled.
Mode

MAC Database Commands

This section describes the commands you use to configure and view information about the MAC
databases.

bridge aging-time

This command configures the forwarding database address aging timeout in seconds. The
<seconds> parameter must be within the range of 10 to 1,000,000 seconds.
Default 300
Format
bridge aging-time <10-1,000,000>
Mode Global Config
no bridge aging-time
This command sets the forwarding database address aging timeout to the default value.
Format
no bridge aging-time
Mode Global Config
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-204